Back to Troubleshooting
Security SystemsBeginner 15-45 minutes
Floodlights do not turn on
Reported Symptom
Floodlights do not turn on
Safety Warnings
- •Some smart fixtures require both power and app settings to allow light output.
- •Do not open an exterior junction box while energized.
- •Use stable outdoor ladder setup and dry conditions where possible.
Possible Causes
- 1No branch power
- 2Wall switch off
- 3Fixture setting issue
- 4Failed light driver or electronics
- 5Loose wiring connection
Tools Required
- Multimeter
- Non-contact voltage tester
- Insulated screwdriver set
- Wet/dry vacuum
- Brush
- Bucket
Parts Required
- Drain tubing
- Drain fittings
- Lamp
- LED driver
- Photocell
- Ballast
Diagnostic Steps
1
Confirm wall switch and breaker status for the fixture.
2
Determine whether the camera portion has any power or signs of life.
3
Check app settings that may disable light behavior if accessible.
4
Inspect wiring condition after power is isolated.
5
Retest after restoring power or correcting settings.
Solution
Recommended Resolution
- Restore line power or correct wall-switch control state.
- Repair loose wiring connections.
- Replace failed fixture electronics if power is present but lights remain inoperative.